We are running Unity 4.2 connecting to a backend exchange 2003 cluster. Anytime there is a failover on the cluster, Unity MWI's freak out and no longer work. No errors occur in Unity and the only apparent way to re-synch is with a reboot.
Go on both your servers under the tools depot and run DBWalker on both servers. It may say you have an invalid switch id or something like that. Essentially, the databases are different. But I have seen it before where the switch id did not match on both servers.
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...
You have reached the Cisco Logistics Support Center.. To Check Status of your RMA, visit Product Returns & Replacements (RMA).
Need help? Contact us by Phone or Email.
Phone: 1800 553 2447 Option 4