I have configured Unity IP FAx service with an offramp gateway on a 2811 (12.4.17a adv enterprise). Inbound faxes are delivered fine. Outbound faxes start transmitting, but the fax connection drops after 30s and a blank page comes out of the receiving fax machine. The receiving fax reports "Poor Line Condition" for the calls originated by offramp gateway tcl script. Other outbound faxes through the same gateway are fine.
I tried using app_faxmail_offramp.220.127.116.11.tcl and app_faxmail_offramp.18.104.22.168.tcl. PSTN connection is a PRI, but I also tried a fax machine connected directly to the gateway via an FXS port with the same result.
No errors are reported when I run debug fax mta all.
An error NDR message is delivered to the sender's mailbox that says:
"The destination system is currently not accepting any messages. Please retry at a later time. If that fails, contact your system administrator."
If anyone has any idea how to troubleshoot or fix this, please let me know.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...