I've been struggling with this BAT problem for some time.
I'm trying to update the Name for a phone (eg: CSF), device profile, Trunk device, etc, using BAT. The obvious problem with this using BAT, is that I'm trying to update the field which identifies the object you are trying to update. A bit of a tail biter.
To explain this in a different way, this would not a problem with SQL, of course, as you can do something like the following: UPDATE device SET name='newName' WHERE name='oldName'
I was wondering if anyone has had luck achieving this within BAT? If the functionality is there imagine it would be through the use of a second 'Device Name' field or something of the likes.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...