Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Upgrade 2620XM

i have 2620XM with 48F and 256D only no any more

i want to run E1 by module VWIC2-1MFT-G703

if i buy PVDM-12 ?   is it enough to run it , am i need any additional module to run PVDM-12 , how many chanel PVDM-12 give me?

ibrahim

best regards

Everyone's tags (2)
1 ACCEPTED SOLUTION

Accepted Solutions

Re: Upgrade 2620XM

You will require a NM to hold the PVDMs

HTH

Please rate this post if was helpful

Walter Solano

CCNA Voice

Cisco UCCX Specialist

4 REPLIES

Re: Upgrade 2620XM

Hello  Ibrahim

The best way to calculate the amounth of PVDMs that you need to acomplish certain tast is using the DSP calculator.

http://www.cisco.com/pcgi-bin/Support/DSP/cisco_prodsel.pl

Also this documents will give you better information about PVDMs

http://www.cisco.com/en/US/prod/collateral/routers/ps5854/product_data_sheet0900aecd8016e845.html

http://www.cisco.com/en/US/tech/tk652/tk698/technologies_tech_note09186a0080a7af82.shtml

HTH

Please rate this post if was helpful

Walter Solano

CCNA Voice

Cisco UCCX Specialist

Re: Upgrade 2620XM

thank you ,

but i need to know if i must have NM-HDV module or i can applay PVDM -12 on  board ,  are there slot in board to applay PVDM or must have NM-HDV?

ibrahim

Re: Upgrade 2620XM

You will require a NM to hold the PVDMs

HTH

Please rate this post if was helpful

Walter Solano

CCNA Voice

Cisco UCCX Specialist

Re: Upgrade 2620XM

Can i hold PVDM-12 in AIM slot ?

Are 2800 also recuired module to hold PVDM2-8 or it has 2 PVDM2 slot ?

thanks

ibrahim

470
Views
5
Helpful
4
Replies