Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Upgrade Check

Current setup- can anyone confirm the below

3 X CM 4.13

2 X IPCC 4.04 (HA)

1X Unity 4.05

CM upgrade to 6.1(2) current HW = MCS-7845-I1-IPC1 (no HW upgrade required)

IPCC upgrade to 5.0(2) current HW = MCS-7835-H1-IPC1 (no HW Upgrade required)

Direct upgrade for CM - using DMA

No upgrade path for IPCC from 4.04-5.0

will need to perform fresh install?

Will I be able to load all scripts created in v4.04 straight into v5.02?

No Unity upgrade required

thanks

4 REPLIES
Hall of Fame Super Silver

Re: Upgrade Check

Your severs will be OK, ensure that they have at least 2 Gb or RAM and 72 Gig drives.

The scripts will work, I suggest that you open them up in new script editor and save to the repository. Alos, dont remember to copy prompts, docuemnts, etc, and any CAD settings.

HTH, please rate all useful posts!

Chris

New Member

Re: Upgrade Check

I have run the Upgrade Assistant on servers that have 32G drives, and it passed. Do you think that is a mistake by the Upgrade Assistant, or does the 72G drive requirement relate to total drive space, including redundant drives in the Array?

Cisco Employee

Re: Upgrade Check

there are some servers that pass the test but the Release Notes explain that for those servers you need to upgrade either RAM or HDD for them to work. meaning that if the server has 1 GIG if you upgrade to the minimum required of 2 gigs it will work.

HTH

javalenc

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
Hall of Fame Super Silver

Re: Upgrade Check

This is normal as the upgrade assistant is probably for CM 4.2 or 4.3 which has different requirements from CM 5/6.

HTH,

Chris

421
Views
5
Helpful
4
Replies