Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Upgrade CM 5.1.2 to 7.0(1)

Hi all,

I have a customer the wants to upgrade the CM versio to 7.0(1). On the cco i fount that to do that i need to go first to 5.1.3 and then to 7.0.1.Doing this i will run two firmware upgrade on the phones. Is there any way to make te upgrade and only make one firmware upgrade.

I was thinking in the folowing procedure:

1 - Install the 7.0(1) firmware file on the 5.1.2 CM.

2- configure on all the phones the new firmware in the firmware load field on the phone configuration.

3- Make the CM upgrade to 5.1.3, at this time the callmanager is with a diferente firmaware version but the phones will not upgrade.

4- Upgrade the CM to 7.0(1)

5- Verify that the firmware is the same on the phones.

6(optional)- Remove the firmware load field on the phones.

Can any one tell me is this a good procedure os if there is others to preform this upgrade.

Many thanks

106
Views
0
Helpful
0
Replies