The following are the steps I took to upgrade from 4.1(3)SR1 to 7.0(2):
On the 4.1(3)SR1 publisher server, I installed and ran the 'CallManager Upgrade Assistant' version 4.3(9) which told me that I had met all of the requirements to upgrade to 7.0(2).
On the 4.1(3)SR1 publisher server, I installed the 'Unified Communications Manager Data Migration Assistant' version 7.0(2) and then ran the DMA Export utility to be able to migrate to 7.0(2). It ran fully and created a successful DMA export with 0 Warnings and 0 Errors in the export file and logs it created.
On the publisher server, using the provided media, I began the installation of the 7.0(2) version. When it asked me if I was going to be using a Windows DMA Export, I said yes and then it asked me if I was wanted to install a patch during the install, again I said yes and provided the 7.0(2a)SU1 patch media to do so. From there it installed just fine and I installed the two subscriber nodes for an uneventful install.
I am slowly converting offices, one at a time to this centralized cluster build. I have already moved over about 800 phones thus far but I caught one with a problem. The 'Product Specific Configuration Layout' at the bottom of the phone device configuration screen was missing - the last item displayed was the 'Secure Shell settings' and as a result, the 7941 was refusing the register to this newly upgraded cluster. I deleted the 7941 from UCM and then re-added it fixing the problem.
I am being told now that doing this upgrade from 4.1(3) to 7.0(2) with the patch upgrade to 7.0(2a)SU1 is not supported and is the cause of this phone DMA migration issue:
I am a little concerned that our upgrade went so smoothly but now we have this one odd phone and possibly others in the database from the DMA export but the provided install and patch media didn't stop me from using a DMA or even give me a warning if this upgrade path isn't supported.
If I just find that I have to delete a few trouble few phones here and there during the migration of the other offices, fine, but I want to see if I could more serious issues here.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...