I want to upgrade cucm 6.1.1 on MCS to 10.0 on UCS can any one just give me any good advice and some small tips i already read some document and check in google but nothing clear , there is to many way ,
Indeed PCD is the way to go, upgrade your current version to supported CUCM that can be used by PCD which I think is either 6.1.4 or 6.1.5, and then use PCD to get to 10.0 or 10.5. Follow PCD admin guide for specific instructions.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...