Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Upgraded from CM 7.1.5 to 8.6.2 - Startup Warning

This is in relation to another discussion I started for the upgrade itself, but since the upgrade is done and this is a different issue, figured I'd start a new discussion.

As the title implies, I just finished an upgrade from 7.1.5 to 8.6.2. My data is all there and working fine in 8.6.2, however each time I reboot the VM's I get the two attached warnings before the VM's will start up.  Anyone seen these before?  How do I get rid of them?

I was thinking about doing a DR backup of my 8.6.2, recreating two new 8.6.2 vm's and restoring to those.  I was thinking maybe something didn't quite go right in my 7.1.5 to 8.6.2 upgrade. ??

3 REPLIES
Cisco Employee

Upgraded from CM 7.1.5 to 8.6.2 - Startup Warning

You need to start by mentioning the details of the upgrade and HW being used.

Was 7.1(5) on VM?? if so, that's not a supported path for upgrading to VM supported version and most likely the cause of the error.

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
Green

Upgraded from CM 7.1.5 to 8.6.2 - Startup Warning

Hi,

As you are upgrading to 8.6.

I think you need to dowload and run

ciscocm.refresh_upgrade_v1.1.cop.sgn

This is an OS patch that is required before the CUCM upgrade can be run.

Please see the read me file on the dowload page

Regards

Alex

Regards, Alex. Please rate useful posts.
Community Member

Upgraded from CM 7.1.5 to 8.6.2 - Startup Warning

I ended up having to built up new machines and just used the Import/Export option under bulk admin from the old servers to the new.  Problem solved.

264
Views
0
Helpful
3
Replies
CreatePlease to create content