Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Upgraded from UCM 4.1(3) to 7.1(3) canlt find incoming calling party national number prefix - MGCP

I looked under Service parameters Cisco Callmanager active and it is not there anymore.  need to change from 91 to 81

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Red

Re: Upgraded from UCM 4.1(3) to 7.1(3) canlt find incoming calli

Hi Wilson,

When you get to Clusterwide Parameters/service parameters for Cisco Communications

Manager Page click on "Advanced" and these parameters will be visible

Cheers!

Rob

2 REPLIES
Hall of Fame Super Red

Re: Upgraded from UCM 4.1(3) to 7.1(3) canlt find incoming calli

Hi Wilson,

When you get to Clusterwide Parameters/service parameters for Cisco Communications

Manager Page click on "Advanced" and these parameters will be visible

Cheers!

Rob

New Member

Re: Upgraded from UCM 4.1(3) to 7.1(3) canlt find incoming calli

Your Awesome Rob.

150
Views
0
Helpful
2
Replies
CreatePlease to create content