Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

'Upgrading" display in 7941 phone on bootup

Have a 7941 that shows an 'upgrading' field (along with a few more columns) along top of display upon initial bootup via POE. Phone won't come out of DHCP disovery.

Never seen anything like that before...is this firmware, software, hardware? Any ideas on fixes or tshooting?

4 REPLIES

Re: 'Upgrading" display in 7941 phone on bootup

Hi friend,

Have you done a packet capture to check for a clue to see what is causing that behaviour?

Regards,

- adrián.

New Member

Re: 'Upgrading" display in 7941 phone on bootup

Hi, I let it fninish the upgrade and its up now...thx.

New Member

Re: 'Upgrading" display in 7941 phone on bootup

I am having the same issue. My phones taking more than an hour to finish upgrading. It is odd because it doesn't seem to be affecting all phones, just some. It is odd, beause phone A and phone B are both in the same switch with identicle port configuration, but phone A comes up in 5 - 10 minutes and phone B takes an hour.

Possibly a cabling issue?

New Member

Re: 'Upgrading" display in 7941 phone on bootup

Has B finished downloading at all?

Perhaps you should start with the cable (L1), then look at the port more closely (verify the correct VLAN, etc), make sure your on the correct port on the phone. Do the typical swap outs to see if the issue follows the cable, port or phone.

149
Views
0
Helpful
4
Replies
CreatePlease to create content