I have a 2960 Gigabit ethernet (WS-C2960G-24TC-L) switch that connects to catalyst 2960 series switches (WS-C2960-8TC). I also have a Cisco Aironet 1230AG Wireless Access Point that will connect the IP phones to the WS-C2960-8TCn switch.
To deploy a WLAN that is voice-services-ready, one must anticipate voice clients' mobile nature and the minimum expectation that calls will not get dropped as users roam across a building or campus. This means that the network must be deployed, with continuous coverage in areas where voice services are planned. The Cisco Unified Wireless Network provides an extensive product line that satisfies the requirements for coverage areas, ranging from just a floor of a building to complete campus coverage, both indoors and outdoors. Areas such as main lobbies, employee entrance areas, parking garages/lots, courtyards, cafeterias and break/copy/supply/storage/cage rooms will need WLAN coverage when voice clients are deployed on the campus. Additional consideration should be given to providing coverage in stairwells, walkways, and elevators, since these are areas where it is reasonable to conduct a business conversation.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...