Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Urgent - PRI

Hello All,

Using PRI in the cisco router. Show inventory providing the T1/E1 info but Im not getting the T1/E1 info in show version. All the PRI cogitation are vanished even unable to reconfigure the PRI ie the router is not accepting the command "controller T10/0/0" in global config mode. I rebooted the router but no luck. Till yesterday it was working fine. 

Version:c2900-universalk9-mz.SPA.151-3.T4.bin

Router : CISCO2911/K9

-Thanks

6 REPLIES
New Member

Urgent - PRI

Hi Murali,

What happens if you type sh diag

Perhaps you have to use another slot, example replace it to slot 2

Strange issue?

New Member

Urgent - PRI

Try to configure your T1E1 from bottom up...

network clock participate wic (X)

network clock select 1 T1 0/0/0

isdn switch type primary- XX

controller T1 0/0/0

framing XX

linecode XX

pri-group timeslote XXX

Hall of Fame Super Silver

Urgent - PRI

sh version does not show the PRI configuration, you need to run "sh run". As suggested run "sh diag" to see if the card is still recognizable in the proper slot and use "sh run" to see the current config.

HTH,

Chris

Hall of Fame Super Gold

Urgent - PRI

card type t1 0 0

VIP Purple

Urgent - PRI

Hi Murali,

What is the Card model u are using ?

please share the exact error message u get while configuring .

regds,

aman

New Member

Urgent - PRI

Thanks for all your assistance. Replaced the PRI card and the issue got fixed.

-M

216
Views
0
Helpful
6
Replies
CreatePlease login to create content