I have a question about the URL Authentication parameter in CUCM 8.5.1. I have a 3rd party vendor that has a client that pushes pages and alerts to our 7925G's. They have an end user setup for authentication in Call Manager and in their program. The paging and alerts are working just fine right now.
Currently our URL Authentication is pointing to our Publisher. We had an issue where the publisher went down and alerts and pages were not being received on the phones any longer. We came to the conclusion that this was happening because the URL Authentication parameter was only set to point to the publisher.
In the vendors program they have defined more than one Call Manager for redundancy purposes. On the Call Manager side it doesn't look to be that easy. The URL Authentication only allows for one Call Manager to be defined. How can I make this redundant?
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...