I have a CallManager Cluster (ver 6.1) and a voice gateway (Cisco 3945). All my other gateways are running mgcp but this one cant as CUCM 6.1 does not support 3945 using mgcp.
Routing to and from a site using a 3945 works 100% using h323. Only problem is that when you’re calling a mobile number, and press decline on the mobile, the Cisco IP phones is still getting a ringback tone for a couple of second and finally gets a user busy tone and message on the screen.
Where can I configure this?
I’ve ran traces on the gateway and I see a User Busy message but CallManager does not clear the call:
025993: Nov 22 14:43:15.722: ISDN Se0/0/0:15 Q931: RX <- DISCONNECT pd = 8 callref = 0xA771 Cause i = 0×8091 – User busy
Never mind. Global config command: voice call disc-pi-off solved the problem.
Getting Started
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: