Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

User Busy Release Message from H323 GW to CUCM 6.1

Hi

I have a CallManager Cluster (ver 6.1) and a voice gateway (Cisco  3945). All my other gateways are running mgcp but this one cant as CUCM  6.1 does not support 3945 using mgcp.

Routing to and from a site using a 3945 works 100% using h323. Only  problem is that when you’re calling a mobile number, and press decline  on the mobile, the Cisco IP phones is still getting a ringback tone for a  couple of second and finally gets a user busy tone and message on the  screen.

Where can I configure this?

I’ve ran traces on the gateway and I see a User Busy message but CallManager does not clear the call:

025993: Nov 22 14:43:15.722: ISDN Se0/0/0:15 Q931: RX <- DISCONNECT pd = 8  callref = 0xA771
Cause i = 0×8091 – User busy

Please advise

1 REPLY
New Member

User Busy Release Message from H323 GW to CUCM 6.1

Never mind. Global config command: voice call disc-pi-off solved the problem.

169
Views
0
Helpful
1
Replies