I'm having an issue using Barge feature on 6901 IP phones.
The scenario required is as follows :
User A (7975) calls User B (6901) and an active call is established. Now User B informs User C(6901) to join the conversation. Unfortunately, when User C goes offhook, he can't join the call already in place.
I've read in the 6901 admin guide that Auto Barge should be enabled. This feature is already enabled by default on the phone configuration page.
Note that Single button is not present on same page.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...