Using Cisco router with 2 CSU/DSU interfaces for B8ZS to AMI conversion
This is going to sound a little strange, but has anyone ever tried to convert a B8ZS/ESF T1 to AMI/D4 using a Cisco router with voice, some DSP voice channels and 2 CSU/DSU interface WICS?
I have a legacy phone system that only supports AMI/D4. The T1 from the Telco is B8ZS/ESF. An Adtran CSU is providing the conversion today but we suspect it is failing. I am sure this is possible using a dialing plan, but I have never attempted it. Anyone have any adivce or pointers?
All of our extensions begin with a 2 and are 4 digits long.
This is what I have today:
voice-card 0 dspfarm !
controller T1 0/3/0 framing sf linecode ami cablelength short 133 ds0-group 1 timeslots 9-16 type e&m-wink-start description TDS T1 ! controller T1 0/3/1 framing esf linecode b8zs ds0-group 0 timeslots 1-8 type e&m-wink-start description Executone
voice-port 0/3/0:1 ! voice-port 0/3/1:0 ! !
dial-peer voice 1 pots description incoming PSTN voice, PRI incoming called-number 2... no digit-strip port 0/3/1:0 ! dial-peer voice 2 pots description incoming voice to Executone destination-pattern 2... no digit-strip port 0/3/0:1 ! dial-peer voice 3 pots description outgoing voice, recieved from executone incoming called-number .......... no digit-strip port 0/3/0:1 ! dial-peer voice 4 pots description outgoing PSTN voice, recieved from executone destination-pattern .......... port 0/3/1:0
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.