Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Using CME as a voice gateway

Hello,

I have a CallManager (v.4.1.3) cluster in the UK and a CME (v4.0) in the USA. They are connecting by a route plan direct to the CME which is setup on the CCM as an H.323 gateway.

At present we only dial extension numbers in the USA from the UK.

I have been asked if I can setup our systems so that we can use an access code to go across our WAN to the USA and then break out on to the USA PSTN system from our CME in the USA.

Does anyone know if this is possible and if so how it should be configured?

Many Thanks

Terry

5 REPLIES
Hall of Fame Super Gold

Re: Using CME as a voice gateway

Yes, it's perfectly possible. Just route so that 001 follow by 10 digits is is routed to the CME, and that's it.

New Member

Re: Using CME as a voice gateway

I have set this as a route filter using the pattern 9.001XXXXXXXXXX and doing a PreDot digit discard.

I have also tried it on the patterns 001XXXXXXXXXX or 1XXXXXXXXXX with no digit discard.

When I call from the UK I get the standard "Your call cannot be completed as dialled" message, which I think is coming from CallManager and not CME.

I must be missing something here....

Hall of Fame Super Gold

Re: Using CME as a voice gateway

Does it have an american accent? If so it's because somewhay, the number is misdialed in the US gateway. Which type of lines do you have in there ?

New Member

Re: Using CME as a voice gateway

All sorted thanks - I had an error in my dial plan, which once sorted I can now dial the contintental US no problem.

Thanks for your help though.

Hall of Fame Super Gold

Re: Using CME as a voice gateway

You're welcome, please rate useful posts using the scrollbox below.

128
Views
4
Helpful
5
Replies