Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

using FXS ports on 2nd VIC card

I have a UC500 with two 4-port FXS cards. The 4 ports on the first card were automatically setup and ephones were configured using the MAC address of the first card. Now I want to use the FXS ports on the 2nd card but I don't know how to get the MAC addresses for the second card. When I do "sho stcapp device summ" I only see the first four ports. What do I need to do here?

Thanks,

Diego

2 REPLIES

Re: using FXS ports on 2nd VIC card

with FXS ports u dont need any mac address and even done need ephon !!!!

can u post ur config

fxs for analog phones

if u have fxs port 0/0/0 connected to analog phone and u want to give it ext. number as 333

u need pots dial-peer as following

dial-peer voice 9 pots

destination-pattren 333

port 0/0/0

good luck

Community Member

Re: using FXS ports on 2nd VIC card

I understand that it will work. However, I want to use the DN and ephone for consistency with the other analog devices. You also get internal caller-id and the extensions are logged in the directory.

Thanks,

Diego

173
Views
3
Helpful
2
Replies
CreatePlease to create content