Hi i have this cm 7.0 installation with AD integration, all the users have + in front of there numbers, when i try to make a transformation pattern that transforms the + to 0 for outside calls it do not work. I have found out that the phone are not sending the + sign so this is why i do not get the match, i am testing with a CIPC. Does anyone have an idea of why the phone are not sending the + sign.?
We just ran into this. It is the firmware on the phone. Check out this Bug CSCsv69814.
Edit: I just noticed that you are using CIPC. That bug is not for the CIPC. The 7940/60 and CIPC seem to automatically strip the + in AD number using the Corporate Directory. However on the upgrade to the 8.4.2 Firmware (during the CM 7.0 upgrade) for the 7941/61/70 . it now tries to dial the +. But the translation rule will not allow adding a + to the rule. So in order to get the + dialing to work you have to downgrade to the 8.1 firmware for those phones.
I had CUCM 7.x out of the box and new phones, and they did not like the - (dash) in the number. If the number was 10-4000, it would reject it in the Directory. CUPC was fine as was Communicator. once we updated the phone firmware, the it dialed fine.
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...
You have reached the Cisco Logistics Support Center.. To Check Status of your RMA, visit Product Returns & Replacements (RMA).
Need help? Contact us by Phone or Email.
Phone: 1800 553 2447 Option 4