09-21-2007 08:20 AM - edited 03-14-2019 11:40 PM
We have setup our voip dial-peers to use the loopback address with the 'voice-class source" command. Thats ok for one direction. Now how do we setup the receiving end to use its loopback address. Is there some command to put on the dial-peer pots entry to force the use of the loopback address on the return packets.
PS In case you have not noticed I know next to nothing about voice, so please forgive if this is an easy, straight forward question.
09-23-2007 09:12 AM
These commands on your loopback interface will source all H323 traffic from the loopback. You do not need the dial-peer voice-class command.
h323-gateway voip interface
h323-gateway voip bind srcaddr x.x.x.x
HTH.
09-24-2007 12:22 PM
There is no h323 gateway explisitly defined anywhere in the config.
09-24-2007 02:24 PM
For H323, you would use the above config. For SIP, there are equivalent commands.
09-27-2007 10:29 AM
Thanks for the replies. I do not know enough to know whether I am using H.323 or sip. Will try the suggestions.
Thanks
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: