I'm working on a qos setup for a customer using a non cisco ip pbx, and I'm told it uses either g711 or g729 codecs depending on available licencies.
So I could get either a 64k or 8k call, which requires different qos policies.
Nbar seems to be the way to classify the traffic, based on RTP PT value, but G711 doesnt appear to have an assigned value.
Currently I'm thinking of configuring my classifier to match a PT value of 18 for G729, and assuming if its not G729 then it must be G711, but that seems a bit crude. Anyone any other ideas on how to do this?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.