I just tried it in mine, and it let me configure it. However, whether or not the phones actually allow you to dial it is another story. Im not understanding your reasoning as far as wanting to use * or # as opposed to the traditional way of configuring intercoms on CME. My intercoms are configured as follows:
Thanks for the post. The reason we wanted the symbols is for end-users only having to remember the extension of the person. Eg. if my extension is 1234, then my intercom would be *1234. I just tested it out and it does work.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...