Using the "Apply Call Blocking Percentage" parameter
Hi Guys, what I need to do is to limit the number of calls going to a particular route pattern during heavy load. So I'd like to see an upper and lower threshold limit on a route pattern where it would start to deny traffic as a %age to a particular route point/route pattern if the upper limit is met over a certain time period. Is this possible? How does the "Apply Call Blocking Percentage" feature when to start blocking calls and is it all the time whatever the traffic load?
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...