Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Using wrong Dial-Peer Destination-Pattern problem

Howdy - I'm troubleshooting a dial-peer problem with a CME system in Singapore. If users dial any toll-free 800 number the wrong dial-peer is used and the number is truncated to match the shorter number-pattern, which of course fails. The number I am dialling in Singapore is 8001204416 (Verizon Audio Conferencing) and it is prefixed with '9' for an external line. All other numbers, including 1800 numbers, work fine (correct dial-peer is used). The correct dial-peer for this number is 2102 (see below), but for some reason this is skipped in preference for dial-peer 2109. I've read through some other posts here looking for any tips or commands/debugs that might help me figure out what is going wrong, but so far I've not had any joy - any hints would be greatly appreciated.

(See attached sho Dial Plan number)

-------------------------

dial-peer voice 2101 pots <--- [** THIS DIAL-PEER WORKS FINE **]

description Toll-free number

destination-pattern 91800.......

translate-outgoing calling 2

port 0/0/0:15

forward-digits 11

!

dial-peer voice 2102 pots

description Toll-free number

destination-pattern 9800.......

translate-outgoing calling 2

port 0/0/0:15

forward-digits 10

[irrelevant bits snipped]

dial-peer voice 2109 pots

description Local fix line, handphone and pager

destination-pattern 9[689].......

translate-outgoing calling 2

port 0/0/0:15

forward-digits 8

-----------------------------

translation-rule 1

Rule 1 ^6394 4

Rule 2 ^62949948 43800

!

!

translation-rule 3

Rule 1 * 9

!

!

translation-rule 2

Rule 1 ^4 6394

!

!

translation-rule 4

Rule 1 ^4.... 63943800

-----------------------------

2 REPLIES
Silver

Re: Using wrong Dial-Peer Destination-Pattern problem

Please configure "forward-digits all" or "no strip-digits". With these commands, no prefix command is necessary.

These URLs might help:

Configuring Call Transfer and Forwarding:

http://cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guide/cmetrans.html

Configuring Dialing Plans:

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guide/cmedialp.html

Dial Peer Features and Configuration:

http://www.cisco.com/en/US/docs/ios/12_3/vvf_c/dial_peer/dp_confg.html

Re: Using wrong Dial-Peer Destination-Pattern problem

Hi Luke, I have noticed that you logged this post a few days ago, were you able to get to the bottom of it?

Although there will be two possible pattern matches for that 800 number, the outgoing call-leg should use dial-peer 2102, simply because it is longest match.

Can you enable 'debug voice ccapi all' and post the results from a test call.

Can you also post a show voice dial-peer summary.

Thanks

Allan.

388
Views
0
Helpful
2
Replies