Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Valcom multi zone paging

All - I am trying to get a Valcom multi zone paging system to work.  I currently can page all zones but can't page each individual zone.  If I connect a butt-set to the Valcom, I can page each individual zone by pressing 0 for all, 1 for warehouse and 2 for office. 

 

I created a dial-peer, and a 329008 route pattern.  Port 1/0/0 is a FXS port. 

When I dial 329008 it just pages all.  It seems to acknowledge when I press 0 or 1 or 2, but it doesn't do anything.   

dial-peer voice 999100 pots
 description 329008 Paging
 preference 1
 destination-pattern 329008
 port 1/0/0

Any suggestions would be appreciated!

 

Thanks,

 

Jaime    

1 REPLY

What is the model of the

What is the model of the paging unit? 2003A???

85
Views
0
Helpful
1
Replies