Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Valcom V-2001a

I see some posts about getting the Overhead paging to work with Valcom v-2001a but I dont see the answers. I know I need an FXO port and thought that we did everything correctly. But it just does not work.

Does anyone have the configuration that I need to do. We are creating a MGCP FXO port

Thank you

Everyone's tags (3)
1 REPLY
Community Member

Re: Valcom V-2001a

The Valcom V-2001A will work with the FXO port using MGCP.  Configuration instructions are posted on the Valcom website at http://www.valcom.com/techsupport/ip_solutions/config-guides.htm .  The instructions should work for all of the Valcom page controllers that use a loop-start trunk port, both single-zone and multi-zone controllers.  If additional info is needed, the Valcom Technical Support department can be reached at support[at]valcom.com, or 1-800-valcom1.

Valcom also provides a full line of SIP-enabled speakers and gateways, which can interoperate with the legacy equipment.  See the full line at www.valcom.com.

Full disclosure: this reply is being made by Valcom Technical Support.

Thank you.

3384
Views
5
Helpful
1
Replies
CreatePlease to create content