Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Valcom V-9970 to 2851 FXS port

Hello All,

           I'am trying to integrate a Bogen Multicom with our phone system.  We have a 2851 and a Valcom V-9970 that goes to the Bogen and connects to our 2851.  I have it connected into an FXS port and I'am using the pattern 31..., They dial 31 then the 3 digits of the room and they can page into that room.  when I dial 31XXX it rings and connects but then it disconnects after 6 seconds.  Here is my dial-peer configuration, am i missing anything specific on this or on the voice port configuration?   Thanks

voice-port 0/1/0

description overhead paging 31...

dial-peer voice 924 pots

description overhead paging

destination-pattern 31...

forward-digits all

port 0/1/0

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Valcom V-9970 to 2851 FXS port

I have a similar setup, but use an FXO port to the paging unit. Is the paging unit you have looking for an FXS port? Also, how many digits is it expecting. You might try only sending the last three (forward-digits 3).

Hope this helps.

Brandon

2 REPLIES

Re: Valcom V-9970 to 2851 FXS port

I have a similar setup, but use an FXO port to the paging unit. Is the paging unit you have looking for an FXS port? Also, how many digits is it expecting. You might try only sending the last three (forward-digits 3).

Hope this helps.

Brandon

New Member

Re: Valcom V-9970 to 2851 FXS port

Thanks for the Reply,  I actually ended up using the FXS and sending 0 digits "forward-digits 0".  The Valcom was just passing 600 ohms to the Bogen Multicom 2000.  So when I dialed my dial-peer and it forwarded 0 digits, I then hit #1 and was able to do an all page.

1266
Views
0
Helpful
2
Replies
CreatePlease to create content