Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Verify this config please

Hi all,

hope Im posting this in the correct section.

I am looking to implement QoS for one application only. I want to dedicate 400k to it. Here is the config I was going to use. How does it look to you?

Class-Map " name of application "

Match protocol " protocol name "

Match access-group 100

Policy-map " name of application "

Class " name of application "

Priority 400

Class class-defualt

Fair queue

Ip cef

Interface " outside interface "

Service-policy " name of application " input

Access-list 100 permit ip (source)x.x.x.x (destination)x.x.x.x precedence critical

thanks a mill

2 REPLIES
Bronze

Re: Verify this config please

The config looks good to me.

Hall of Fame Super Silver

Re: Verify this config please

Are you going to match both the ACL and the protocol, or one of them?

If both of them have to match then you are set, if either one of them make the change:

Class-Map match-any " name of application "

Chris

92
Views
3
Helpful
2
Replies
CreatePlease to create content