I wish to setup a very basic lab for testing Cisco IP phones. All I wanted is to connect two Cisco IP phones together via a Cisco router. Configure the router and be able to make some test calls.
Is this possible? What models of Cisco routers can I use to set this lab up? Do I need any particular IOS or other software running on this router to be able to setup this lab? Do I need any special cards on the router?
Are there any sample Cisco router configs that I can use?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...