Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

VG202/4 Initial configuration

Hello.  Im looking for a way to config one remotely, without using the console cable.  It seems the product comes shipped with no telnet password / username.    I normally have to console in and supply one, then I can do the rest remotely.  Is there a way to get around this ?

thanks     

1 REPLY

VG202/4 Initial configuration

Get a KVM and connect it to the console of the VG and or have someone on site configure the VTY lines.

HTH

Regards,

Yosh

HTH Regards, Yosh
119
Views
0
Helpful
1
Replies