I have multiple environments with Avaya Partner phone systems in them. I used touse a multitech VOIP modem for connection back to Headquarters - this works perfectly fine. Situation I am having, when the Multitech units die, I replace them with the Cisco VG202 unit. When placed at the remote locations, the time in the windows of the Avaya phones never corrects it self...it always wrong. It is correct on the Avaya system at the location, but the integration of the Cisco unit seems to make it go awry. All other functionality is there, but the time display is a mess. Any ideas as to where to troubleshoot this? Manually establish the correct time from a console phone at the remote locations, and it goes awry within hours.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...