Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

VG224 Analog fax

What is the command to reset voice ports on a vg224? I know the shut/no shut commands. But I need the command to interface to a port so that I may issue the shut/no shut. Any assistance would be great!

5 REPLIES

Re: VG224 Analog fax

You can just do a reset from call manager and it will solve this... What protocol is the VG224? If it is SCCP this should do the trick...

Cheers,

Chad

New Member

Re: VG224 Analog fax

Thanks, Chad. The issue is that some numbers on the VG224 are giving a "fast busy" signal when dialed. I have attempted to reset the gateway and the port from the Call Manager console (4.1(3)r6a). and I tried the reload command from the CLI. Do you have anymore suggestions? Thanks!

Re: VG224 Analog fax

Well I can only imagine if you tried all that, its either a class of service issue within the call manager itself, or possibly there is a punch down problem?

Chad

New Member

Re: VG224 Analog fax

that is a possiblity. But, I would like to try the CLI command that allows me interface to the port so that I can reboot it from the CLI. I failed to mention that it is a MGCP gateway. Thanks for your responses.

Re: VG224 Analog fax

if you already reloaded the router, then that reset all the ports anyways.. the shut no shut on the voice-port is as you said the other options...

Chad

444
Views
0
Helpful
5
Replies
CreatePlease to create content