Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

VG224 Analog Port Busy Tone when Offhook

Greetings we have a number of tenants using analog ports off VG224's....initially there were programmed as POTS however many phones where not able dial out as the phone would immediately go busy when off hook (no input from keypad)....different phones and ports. After an inbound call was answered on that port, the busy condition went away and proper dial tone was received - however the busies would return. We changed these ports to LOOP and it seemed to work for weeks, however the intermittent problem is back (less frequently than POTS).

Any ideas how to resolve this? FYI when proper dial is received in/out calling is fine.

Thanks

296
Views
0
Helpful
0
Replies