I`ve now configured the VG224 as SCCP in CCM and with
SCCP CCM X.X.X.X PRIORITY 10
SCCP CCM SRST PRIORITY 20
All is working with the VG being registered with the SRST router in fall back mode . If I do a SHOW EPHONE REGISTER on the SRST I can see the ANG GW and if I do a SHOW SCCP ALL on the VG224 I can see the ports registered also to the SRST Router however if I call one of the ports based upon the DN I`ve configured in CCM I get busy. I`ve configured on the Voice-port in the VG224 CALLER-ID ENABLED - any ideas. Also if I do a SHOW EPHONE REGISTERED in the SRST router I can see the DN`s of my other IPT Phones- 794x, 76x but where on the same output would I see Analogue port DN`s
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.