Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VG224 configuration with CUCM 6.1

I have installed a vg224 voice gateway along with our cucm6.1 and have been unable to get a analog phone to work with it. The vg224 has been entered into the cm administration under gateways with sccp. I have attached a analog phone to the vg224 and configured it in the cm adminstration with a number assigned. What else am I missing to get this to work. I have only had experience with the older vg248 which was not ios based.

4 REPLIES

Re: VG224 configuration with CUCM 6.1

You need to make sure you configured sccp connection on that vg224. Make sure that it is registered to call manager. Here is a sample configuration of the vg224 configured as a sccp gateway in call manager.

sccp local FastEthernet0/0

sccp ccm X.X.X.X identifier 10

sccp ccm X.X.X.X identifier 12

sccp

!

sccp ccm group 1

associate ccm 10 priority 1

associate ccm 12 priority 2

stcapp ccm-group 1

stcapp

dial-peer voice 1 pots

service stcapp

port 2/1

dial-peer voice 2 pots

service stcapp

port 2/2

etc....

Do a "show sccp" to see if the device is registered to call manager.

New Member

Re: VG224 configuration with CUCM 6.1

Thank you very much. That resolved the problem.

Re: VG224 configuration with CUCM 6.1

Rated Kelvin's post based on bronski's reply.

Re: VG224 configuration with CUCM 6.1

Thanks!

375
Views
15
Helpful
4
Replies