I have one vg224 that i have binded with cucm with mgcp protocol. I have given 2001 extension to my ip phone. And now i want to give same extension(2001) to 2 Analog phones that is connected to 1st and 2nd port of vg224. How can i do this. I am using cucm 8.0
On the gateway config page of VG224, click on the fxs port 1, it will take you to a page where you can add a line to that FXS phone. There you can add extension 2001 which will show up basically as " shared line " as that 2001 is alredy assigned to your IP Phone. Repeat the same steps for Port 2.
Pls rate helpful posts by clicking on stars below the post !!
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.