m into crazy issue with mgcp VG224 some ports not showing correct status, when i dial port it plays busy infact port is available.Even no output from debug vpm signal.This is happeinng on some ports on same VG.Resetting @ VG & UCM doesnt solve it,even reload of VG224.
We had the exact same issue on several VG224. Turned out to be an IOS bug resolved in 12.4(24)T. Since upgrading to this release, we have not had this happen again. Prior to this IOS upgrade, only resolution was a to reload the VG224. A reset in Call Manager for a given port would resolve issue for a sort time some of the time.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...