We have couple of VG224's ( SCCP) connected with panasonic analog phones. During the peak hours when we dial those numbers, from an IP Phone in the screen we see the error message " Not enough bandwidth" this is happening only for few analog extns, but when we diall IP to IP phone there is no issues, moreover all the Phones are in single location. VG224 is registered to the CUCM in a different location. Any help??????????? Thanks in advance...
Sounds like you are exhausting all the location bandwidth allocated to the Gateway, if the VG224 is physically at the same location as the IP phones, why do you have different Location assigned to it? Remember Location is strictly used for Call Admission Control and that is exactly what you are seeing.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...