VG224 , Not enough bandwidth error

[problemchild27]

Hi,

    We have couple of VG224's ( SCCP) connected with panasonic analog phones. During the peak hours when we dial those numbers, from an IP Phone in the screen we see the error message " Not enough bandwidth" this is happening only for few analog extns,  but when we diall IP to IP phone there is no issues, moreover all the Phones are in single location. VG224 is registered to the CUCM in a different location. Any help??????????? Thanks in advance...

[Jefferson Islan Silva]

Hi,

What's the codec and location bandwidth are you using between this sites?

[Chris Deren]

Sounds like you are exhausting all the location bandwidth allocated to the Gateway, if the VG224 is physically at the same location as the IP phones, why do you have different Location assigned to it?  Remember Location is strictly used for Call Admission Control and that is exactly what you are seeing.

HTH,

Chris