Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

VG224 SCCP and Modems..

I am cureently trying to get modems to work over an SCCP VG224 with CallManager 7.  At present the modems can recieve but cannot send.  The PSTN gateway they are using is MGCP and everything is configured for Modem Pass through end to end.  Has anyone seen anything like this before?

Thanks,

Justin

3 REPLIES
Hall of Fame Super Gold

Re: VG224 SCCP and Modems..

Modem passthrough doesn't seem a good idea.

Should use modem relay and H.323.

Or place FXS cards in router, end of any trouble,.

Bronze

Re: VG224 SCCP and Modems..

I found that VG224's are great for Fax's, but not for modems. I use ATA

186/188's for modems as they worked without any issues.

Phil

New Member

VG224 SCCP and Modems..

Maybe a little on the late side but... have a VG2951, VG224 CUCM 7.1.3 H323. Gas company calling inbound on DID line through VG224 and they could not connect did the changes to the port below and Gas compnay can now connect to modem, all the best.

conf t

voice-port 2/xx

shut

input gain 6 <-- normally at 0

output attenuation 10 <-- normally at 0

idle-voltage high

no shut

end

write memory

show run and look for port

!

voice-port 2/11

input gain 6

output attenuation 10

timeouts initial 60 <-- was already set to this

timeouts interdigit 60 <-- was already set to this

timeouts ringing infinity <-- was already set to this

description Gas Modem Line x143 <-- add a description for me

!

1817
Views
0
Helpful
3
Replies