12-04-2006 11:24 AM - edited 03-14-2019 07:04 PM
Does anyone have a sample SCCP configuration for a VG224 Gateway? I have the device set up in CallManager, but I know my configuration on the Gateway is probably not right. Can anyone help? Thanks
12-04-2006 02:53 PM
12-05-2006 07:02 AM
Thanks for the reply...however this configuration is for MGCP, does anyone have one for SCCP?
12-05-2006 07:09 AM
Try this
stcapp ccm-group 1
stcapp
!
voice-port 2/1
caller-id enable
!
voice-port 2/2
caller-id enable
!
sccp local FastEthernet0/0
sccp ccm 1.1.1.1 identifier 1
sccp ccm 1.1.1.2 identifier 2
sccp
!
sccp ccm group 1
associate ccm 1 priority 1
associate ccm 2 priority 2
!
dial-peer voice 1pots
service stcapp
port 2/1
!
dial-peer voice 2 pots
service stcapp
port 2/2
HTH
Sankar.
PS: please remember to rate posts!
12-05-2006 08:22 AM
It's still not working correctly. Is there more to this config that is missing? As soon as I pick up the handset I get a busy signal.
12-05-2006 08:47 AM
Can you paste a sh sccp output ?.
12-05-2006 09:04 AM
SCCP Admin State: UP
Gateway IP Address: 10.1.40.6, Port Number: 2000
IP Precedence: 5
User Masked Codec list: None
Call Manager: 10.1.40.11, Port Number: 2000
Priority: N/A, Version: 3.1, Identifier: 11
Call Manager: 10.1.40.10, Port Number: 2000
Priority: N/A, Version: 3.1, Identifier: 10
SCCP application services(dspfarm profiles) are not enabled
or haven't associated to SCCP CCM group
12-05-2006 09:36 AM
Alright, got this working now. Anyone looking to do this configuration, please refer to this document.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: