I have a VG248 gate that is continiuosly rebooting, However i have remove the gateway from production and kept it for standalone without any connectivity and then tried to boot but still it us rebooting,
Can any one suggest what can be the issue.
Its running image 1.3....
Also plz suggest what else can be checked as i have already removed the box from production and tested it standalone i ahve also reset it to default so no configuration is there.
There is a menu option in the VG248 where you can view the environmental status. It will show you power and environmental information. You should check this out. I had a vg248 that was continuously rebooting and it was related to the 1.8 volts power supply. You can access the environmental status information by going to Diagnostics>Show Environment.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...