Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VG248 Line Voltage

Hi Guys,

I have a problem where by i have an analouge phone hanging off a VG248 - all working fine, except this phone is a nurse call phone and requires a certain voltage running down the line. Can anyway give me the line specifications that the VG248 produces?

Thanks

2 REPLIES
Green

Re: VG248 Line Voltage

Have a look at this URL. It's at the bottom of the page where it shows the ringing voltage specifications. Hope this is what your looking for.

http://www.cisco.com/univercd/cc/td/doc/product/voice/c_access/apg/vg248/v1_

0/hard_ins/vg248hws.htm

Take a look at CSCdu79519

Internally found moderate defect: Closed (C)

Voltage may be too low for some phones MWIs

Hall of Fame Super Red

Re: VG248 Line Voltage

Hi Ben,

Just to add a note to the good info from Gonz;

Technical Specifications - VG248

Power

100-240 VAC, 50-60 Hz

Talk battery

-35V

Ringing voltage

46V rms with a 14V DC offset

Loop current

21 mA

Message-waiting voltage

93V DC (one second on, one second off)

Maximum line length

5000 feet or 415 ohms (on-premise only)

REN equivalence

3 (maximum 2 off hook)

Connectors

Two RJ-21 female

Off-hook detect

Loop start only

Dialing

Dual tone multifrequency (DTMF) only

From this doc;

http://www.cisco.com/en/US/products/hw/gatecont/ps2250/products_data_sheet09186a008007c9bb.html#wp38824

Hope this helps!

Rob

197
Views
0
Helpful
2
Replies