I have (another) weird one. I have 4 VG248s in use but the 4th one (installed post cutover by vendor)is not working properly. Only 3 lines will register and with Publisher not Subscriber. All other ports "register: unknown". They are all set up with dns and when I check with butt set I get reorder tone. Any ideas or suggestions? Thank you inadvance for your time.
I checked the DP and it's the same as the 3 VG248s that are working. We only have one CM with a Pub and a Sub and no groups (not an option in 3.3?) As for the telnet session... requires a password which I don't have.
I think I'm going to have to ask my current vendor to reconfigure the password on the VG248 and check the config. I was trying to avoid it but don't see any other options. :-(
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...