We recently deployed VG30D for QSIG to DPNSS conversion to a GTN network. However we are having issues with two of the sites.
When the "CLI" is sent along with the called number, the GTN switch breaks the called number up (i assume its using over lapping digit sending)
eg called number is 60866543, the digits received at the terminating gateway is "6086" then "6543". Other times we only get the first part of the digit string and we dont get the remaining digits sent. I have configured " isdn over-lap receiving" but calls are still not working.
Please rate all useful posts
"The essence of christianity is not the enthronement but the obliteration of self --William Barclay"
IntroductionCUCM Routing RulesDial String implementation PolicyCUCM Routing LogicSIP URI Call Routing Analysis+++ Case Study: 1 ++++++ Case Study: 2 +++Conclusion
Over the last few months, I have had the privilege of working on SI...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...