Hi - it has been a little while since i configured a VG30D, but seem to be having some fundamental issues on both QSIG RJ45 E1 and DPNSS coax sides. I have connected QSIG RJ45 end via stub crossover connected to a straight through to 2951, trying all permutations at VG30 and 2951 ends (network / user / framing / line / qsig / q931 / various clocking settings) I continually get layer 1 transmit / recieve errors. My next step is to try a crossover E1 but i was sure when we connect via the supplied stub we can just use a straigh through?
i am also getting the same errors on the DPNSS side but will the PBX provider is looking at some potential issues at their end.
thanks Alex, i have reloaded and tried all permutations and gone through docs but cant seem to get layer1 to stop alarming... very strange. Do you know if we can get the QSIG end up even if there is an issue on the DPNSS / PBX side? as I have set up a lot pf QSIG/Q931 ccts in the past but these ones just wont see l2.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.