I have a VG350 Version 15.3(3)M2. According to the Cisco Feature Navigator (see attached pictures), , this supports Ether-Channel for both “Link Aggregation Control Protocol (LACP) (802.3ad) for Gigabit Interfaces” and “EtherChannel - Flexible PAgP” and is listed for the VG350 and ISR3945E. The ISR3945E is able to be configured for Ether-Channel, however on the VG350, I am unable to add any of my Gigabit interfaces into a channel group ??
I don't want to use a BVI unless I have to, particularly when we have told the customer we can now support Ether-channel and the design has been based on this. As a sanity check, I checked the feature navigator for a VG224 and this DOES NOT indicate support for Ether-channel as I would expect as I know it is not supported.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...