Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

VGD With H.323/CUCM 4.2 and Multiple LD PRI's

Hello all,

I am sorry if this is a repost.  I need to setup a VGD with H.323 because the version of CUCM that I am on will not allow for MGCP.  I am new to H.323 and I am trying to figure out how to make sure that LD traffic goes over a specific PRI.  Isn't this done in dial peers?

I have a mock example for you to consider:

Let say, for the sake of this example, that after I configure the T3 card all my voice-ports will look like the following:

voice-port 1/0:1:D
!   - - -  OMITTED - - -
voice-port 1/0:28:D


In this example our LD PRI's would be port 7 and 8.


I was thinking that my H.323 dial peer configuration for LD would look something like this:

National:

dial-peer voice LD-National_1 pots
destination-pattern 1[2-9]..[2-9]......$
port 1/0:7D
forward-digits 11
preference 1

dial-peer voice LD-National_2 pots
destination-pattern 1[2-9]..[2-9]......$
port 1/0:8D
forward-digits 11
preference 2


International:

dial-peer voice LD-International_1 pots
destination-pattern 011T
port 1/0:8D
no digit-strip
preference 1

dial-peer voice LD-International_2 pots
destination-pattern 011T
port 1/0:7D
no digit-strip
preference 2


I was thinking that based on this configuration, I am pointing specific patterns to specific ports for LD National and International.  Is this the correct way to handle National and International dialing.

Please let me know and thanks for your help!

1 REPLY
Hall of Fame Super Gold

VGD With H.323/CUCM 4.2 and Multiple LD PRI's

Seems correct to me.

144
Views
0
Helpful
1
Replies
CreatePlease to create content